[China Button Industry Network] The five-claw button and the snap button are the most common buttons. In the process of use, they will encounter more or less unexpected things. Due to the different button structures, each type of button The problems that arise are also different. The five-jaw buckle is one of the buttons. Take a look at the five-jaw buckle. Whether it is a four-button, an I-button, or a 5-jaw button, the nail must be adhered to the following principles when adjusting the die: First, the upper die and the lower die must be concentric, that is, the upper die and the lower die must be corrected, when they are concentric. The upper die and the lower die can be accurately matched and the buttons that are punched out will not fall out. Second, the machine can not be adjusted too deep when adjusting the pressure, it is too dark and easy to change the button to guide the button to damage or fall off, adjusted too shallow pressure is too small and afraid of the button is not easy to fall off, so more The depth of playing the mold is based on experience. The easiest way is to use the button after the back. Pull it out with a vise. It's hard to pull it out and it's much worse. Whether it's a motor, or a motive, or a foot machine, it's the same thing. At that time, it scratched the eye and the eye was following the above principles. What should be paid attention to in the binding of the five-jaw buckle? 1. There is tightness and looseness in the fastening force. If A is OK before playing, press the button machine to adjust it too low. B may be mixed with products that are not the same as other manufacturers. C mode has problems. 2. Destructive power is not enough, it is easier to fall off. A button machine closed height adjustment is not good. B fabric is too thick or claw length is not enough. C claw material is too thin, not enough hardness. 3. There are claws. A button machine is not vertical up and down, eccentric B male and female deduction buckle is too low or too narrow, and the gap between the claws is not enough (can not be detected before the hand can be used) C if the claw face this situation may be caused by too long claws Use short claws instead. 4. When the button is pressed, the claw breaks off. A button machine tune too low. B paws are too hard to bend. There is a problem with C plating, which causes the claws to become hard and brittle. In particular, the deplating (after replating another color after plating the color) is very likely to result. The back space and shape of the D male and female buckles are not good enough to break off the claw feet. 5 The paint peels off when it is painted with a five-jaw clasp. The shape of A die does not match the shape of the claw face. B paint quality is not good, general miscellaneous brand paint adhesion is poor. C Degreasing before painting is not clean. D If using ironing, be careful not to cause problems so as not to damage the paint. Want to learn more about buttons: accessible Lace Sock,Lace Socks For Women,Summer Lace Socks,Lace Invisible Socks Jingjiang Pingdong Import&Export Co.,Ltd , https://www.socksjjpd.com